Motion Sensor Light Switches

Exhaust the footage tester to manufacture obvious power is flowing to and from the fixture. Then turn off the power again and connect each wire pair with a wire nut, and conceal them with tape to waterproof your splice.

Step 3 - Installing

Next, tuck the connected wires into the junction box and establish the fixture housing over it. After mounting the fixture to the box with the provided screws, effect definite that all the wires are now completely contained and protected by the housing fixture and are unexposed.

Step 4 - Installing the Light Bulb

Lastly, install the bulb. He wears lightweight gloves to install the fixture's halogen bulb. Seal the housing and reactivate the circuit. You should test the light at night with the switch first. Leave the switch in the ON situation and do not fade, waits for the light to turn off. It should only occupy a few minutes.
Motion Sensor Light Switches
...